Issue Date: 09-25-07 Rev. Date: 04-24-08 Rev. Level: 03 ECN: n/a OIPM P/N: 3420203
Page 5 of 8
HEATER INSTALLATION continued
SUSPENSION ALTERNATIVES
Your OCH-SS series heater can be mounted with either
adjustable mounting brackets or chain suspension. Both
options are included with your heater.
Standard Mounting:
In the hardware bag shipped with your heater you will
find two adjustable mounting brackets and fastening
hardware. Using the mounting centers specified in
figures 1 & 2, mount your adjustable mounting
brackets (bends to the inside). Once mounted,
assemble the heater to brackets (figure 3) with
mounting hardware, these brackets enable the heater to
be angled in 15-degree increments up to 45 degrees.
Chain Suspension:
The heater can also be chain-hung as shown in figure
4. Cut the 16ga. chains (two 4 foot chains are
provided) to desired length. Attach chains to heater
with “S”-hooks provided and suspend from overhead
structure. Crimp “S”-hooks closed after assembly.
Figure 1: end view
Figure 2: side view
Figure 4: end view
Install heater so that the quartz tubes are
horizontal. Failure to do this may cause the heating
element within the tube to sag and cause premature
burnout.
ELECTRICAL SHOCK
HAZARD
•
Serious injury or death
may occur.
•
Disconnect from electrical
supply before installing or
servicing this heater.
•
Read and follow
installation clearance
requirements on page 4.
Adjustable mounting brackets
OCH46 = 41.0
OCH57 = 52.0
Figure 3: mounting view
10-32 Nylon
Lock Nut
Mounting
Bracket
10-32 x ½”
Screws
