FI8906W Quick Installation Guide
www.foscam.com
- 20 -
Step 03)
Please click on the
Submit
button after all settings have been entered, the camera will
reboot. After the camera has completed the reboot process, wait 10 seconds and disconnect the
network cable.
The LAN IP address will disappear on the window of IP Camera Tool when the camera gets restarted.
Just wait for around 1 minute, the camera will get wireless connection, and the LAN IP of the camera
will be showed again on the window of the IP Cam Tool. You have done wireless connection of the
camera successfully. If the camera has a dynamic IP, after the wireless settings, the IP will be
changed.
If fail to make WiFi connection, please make sure wireless signal is
strong enough first, then you can refer to seller or FOSCAM for help.
4.2 WPS (Wi-Fi Protected Set-up)
Step 01)
Press and hold the RESET button for
four seconds.
Step 02)
Press the WPS button on your router
within 60 seconds
. The WPS button is usually on
the back or side of your router. On some routers, you may need to log in to the web interface and
click on an on-screen button to activate the WPS feature. If you are not sure where the WPS buttons
is on your router, please refer to your router
’s User Manual.
The camera will automatically create a secure wireless connection to your router. If you have
plugged in the network cable, please plug it out. While connecting, the green network light on RJ45
will blink and the wireless settings will take effect. The IP Camera Tool will search the camera
’s LAN
IP. Make sure the PC and the camera share the same subnet.
1 During the WPS Settings, you must press the Reset button only for four seconds, or else, the
camera may be reset back to factory default settings if you press and hold on the reset button above
10 seconds.
.2 The security mode of router cannot be WEP, or else the WPS settings may be failed.
Note
Note
Reset Button