11
Following are a few common problems that may occur during operation.Here are some suggestions for
easy troubleshooting:
1.
The unit does not work, no light and the fan does not work
•
check the connection of power and main fuse.
•
Measure the mains voltage on the main connector.
•
Check the power on Led.
2.
Not responding to DMX controller
•
DMX LED should be on. If not ,check DMX connectors, cables to see if link properly.
•
If the DMX LED is on and no response to the channel, check the address settings and DMX polarity.
•
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the unit
or the previous one.
•
Try to use another DMX controller.
•
Check if the DMX cables run near or run alongside to high voltage cables that may cause damage
or interference to DMX interface circuit.
3.
Some units don’t respond to the easy controller
•
You may have a break in the DMX cabling. Check the LED for the response of the master/slave
mode signal.
•
Wrong DMX address in the unit. Set the proper address.
4.
One of the channels is not working well
•
The stepper motor might be damaged, or the cable connected to the PCB is broken.
•
The motor’s drive IC on the PCB might be out of condition
5.
Fixture Cleaning
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates:
damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit’s optics.
