2
Thank you for choosing our products. For your own safety, please read this manual before
installing the device. This manual contains important information on installation and applications.
Please install and operate the fixture with following instructions, make sure the power is off
before opening the light or repairing. Meanwhile, please keep this manual well for future needs.
It is made of a new type of high temperature strength of engineering plastics and cast aluminum
casing with nice outlook. The fixture is designed and manufactured strictly following CE standards,
complying with international standard DMX512 protocol. It’s available independently controlled
and linkable with each other for operation. And it is applicable for large-scale live performances,
theater, studio, nightclubs and discos.
Safety Instructions
This device has left the factory in perfect condition. In order to maintain this condition and to
ensure a safe operation, it is necessary for the user to follow the safety instructions
and warning notes written in this user manual. If the device has been exposed to temperature
changes due to environmental changes, do not switch it on immediately. The arising condensation
could damage the device. Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore, it is essential that the device be earthed.
Note:
Damages caused by disregard this manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
The electric connection must carry out by qualified person. The device shall only be used with
rate voltage and frequency. Make sure that the available voltage is not higher than stated at the
end of this manual. Make sure the power cord is never crimped or damaged by sharp edges. If
this would be the case, replacement of the cable must be done by an authorized dealer. Always
disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord. During initial start-up
some smoke or smell may arise. This is a normal process and does not necessarily mean that the
device is defective, it should decrease gradually. Please don't project the beam onto combustible
substances. Fixtures cannot be installed on combustible substances, keep more than 50cm
distance with wall for smooth air flow, so there should be no shelter for fans and ventilation for
heat radiation. If the external flexible cable or cord of this luminaire is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar qualified person in order
to avoid a hazard.
Key Features
Содержание FOS Glow
Страница 1: ...1 FOS Glow...
