5
9.
Internal drying button
Press the internal drying button for 3 seconds to activate the internal drying function. The internal
drying indicator will start flashing. It will take around 1 hour for the whole cycle.
It operates with high fan speed and the air deflector keeps upright for 30 minutes; then it operates
with high fan speed and the air deflector starts swinging for 10 minutes; then the air deflector turns
back to the upright position and operates with high fan speed for 15 minutes.
Press the internal drying button for 3 seconds again to deactivate this function.
It can help to dry the vapor in order to prevent moldy and odor before storage.
10.
Memory Function
Press the ON/OFF button to turn off the appliance. Press the ON/OFF button again to turn it back
on; or unplug directly or power cut, then reconnect the power supply again, the dehumidifier will
operate by the mode set before shutdown, but timer function is not applicable.
PRECAUTIONS
1.
The humidity setting should not be set higher than the ambient humidity to operation.
2.
When the water tank is full or the water tank full indicator turns on, drain the water, and install the
empty water tank back to its position. The appliance will continue its operation.
3.
The operational temperature range of this appliance is 5-32
o
C.
4.
If the plug and power supply are in normal condition, and the dehumidifier does not start, please
unplug it, wait for 10 minutes, and restart the appliance (as it takes around 10 minutes to reposition).
If the appliance still does not start after 10 minutes, please contact the service center.
5.
When the dehumidifier is in operation, the running compressor will get hot, and the room
temperature will be increased. This is normal.
6.
The built-in defrosting sensor detects room temperature and will cease the operation of the
compressor for about 10 minutes when room temperature is below 15
o
C and the low temperature
indicator “
” will turn on. When the room temperature is below 2
o
C, the low temperature
indicator will start flashing.
DRAINAGE INSTRUCTION
While the water tank is full, the water tank indicator will be on. The compressor and the fan will stop
operating. Please empty the water tank.
*Please turn off and unplug the appliance before removing the water tank.
1.
Remove the water tank carefully. (Fig. 1)
2.
Remove the tank lid and empty the water tank.
3.
Put the lid back and insert the water tank gently back into the appliance. (Fig. 2)
Fig.1
Fig.2
