4
5.
Wind direction button
Press the wind direction button to set the direction of the air deflector and activate the movement
of the air defector.
will be flashed in cycle. Press again to deactivate it.
Note: this function is invalid under shoes drying mode.
6.
Speed button
Press the speed button to set the wind speed: high, medium, low. The wind speed icon “
” will be
shown on the LCD display. The flash frequency indicates the wind speed.
7.
Auto button
Press the auto button to run in automatic operation mode:
RH > 60%: the compressor will run with high wind speed.
60% ≥ RH > 55%: the compressor will run with medium wind speed.
RH ≤ 55%: the compressor will stop and run with low wind speed.
8.
Key lock
Press the Up/Down key at the same time for 2 seconds to lock all the keys. The key lock icon
“ ”will be shown on the LCD display. Press the Up/Down button again to cancel the key lock
function.
9.
Memory Function
Press the ON/OFF button to turn off the appliance, then press the ON/OFF button again to
turn it back on: the dehumidifier will run by the mode set before shutdown; timer function is
not applicable.
Unplug directly or power cut, then reconnect the power supply again: the appliance will run
by the mode set before shutdown; the timer setting will continue to run.
If press the ON/OFF button to turn off and unplug the appliance, then reconnect the power supply
again, the appliance will run as factory setting mode.
PRECAUTIONS
1.
The humidity setting should not be set higher than the ambient humidity to operation.
2.
When the water tank is full or the water tank full indicator “
” turns on, drain the water, and install
the empty water tank back to its position. The appliance can continue its operation.
3.
After the power is off, wait for 3 minutes before restarting the appliance to protect the compressor.
4.
The operational temperature range of this appliance is 5-35
o
C.
5.
If the plug and power supply are in normal condition, and the dehumidifier does not start, please
unplug to wait for 10 minutes and restart the appliance (as it takes around 10 minutes to reposition).
If the appliance still does not start after 10 minutes, please contact the service center.
6.
When the dehumidifier is in operation, the running compressor will get hot and the room
temperature will be increased. This is normal.
7.
The built-in defrosting sensor detects room temperature and will cease the operation of the
compressor for about 10 minutes when room temperature is below 15
o
C. Defrost indicator “
”
will be on when the appliance is in the function of defrosting.
