ES820 Hardware Guide: Specifications
10
4.1.3
Compliance and Standards
The Fortress ES820 is certified by the Wi-Fi Alliance® for the
following standards:
4.2 37-Pin Input/Output Connector
The connector on the rear panel of the ES820 provides all non-
radio input/output for the unit. In order to connect to the ES820,
a cable with a matching connector must be made, using the
required connector type:
Figure 4.1. MIL-DTL-38999 Series III TV Shell/Insert 15-35 (socket)
Table 4.1 defines the pin-out required for the ES820 cable
connector. Most definitions are standard (ex., Ethernet, serial,
and USB). Five pins are unique to the ES820:
Power
(pin 33 - active lo) - powers the ES820 on and off.
When this pin is toggled lo, the unit is permitted to power up
and boot. The switch state is tied to the chassis ON/OFF
switch: both switches must be OFF to turn the unit off. Tie
this pin to a toggle switch.
Blackout
(pin 24 - active lo) - controls blackout mode, which
turns all chassis LEDs OFF. When this pin is held lo, all of
the LEDs on the box are dark at all times. When the pin is
not held lo, LEDs revert to normal operation. This pin would
commonly be tied to a toggle switch.
emissions:
CE, FCC, ETSI, MIL STD 464A, MIL STD 461F
immunity:
MIL STD 461F
vibration:
MIL STD 810G
IEEE:
802.11a/b/g
security:
WPA™, WPA2™—Personal and Enterprise
EAP types:
EAP-TLS, EAP-TTLS/MSCHAPv2,
PEAPv0/EAP-MSCHAPv2, PEAPv1/EAP-GTC,
EAP-SIM, EAP-AKA, EAP-FAST
1
21
31
11
