Fortinet FortiWiFi FortiWiFi-60B, Инструкция по установке

Страница: 49 / 82

Using a wireless network Setting up the FortiWiFi unit as an access point
FortiWiFi-60B FortiOS 3.0 MR6 Install Guide
01-30006-0447-20080131
49
Configure the wireless interface
Configure the wireless interface, WLAN, on the FortiWiFi unit for use on the
network.
To configure the wireless interface
1 Go to System > Wireless > Settings .
2 Select the WLAN interface.
3 Enter the following settings and select Apply.
Configure the security options
To ensure proper security and protection of your network and its information, set
the security options for the FortiWiFi unit.
To set the data security
1 Go to System > Wireless > Settings .
2 Select the WLAN interface.
3 In the Wireless Settings area, set the following:
4 Select Apply.
5 Select the MAC Filter tab.
6 Enable MAC filtering if desired and select Edit.
7 Enter the MAC addresses and select to Allow or Deny them from the wireless
network.
8 Select OK.
Address Mode Enter a static IP and netmask for the interface. DHCP and
PPPoE are not available on a wireless interface.
Administrative Access Select the methods that administrators can connect to
administer the FortiWiFi unit using the wireless interface.
Administrative Status Ensure this is set to Up. Otherwise no traffic can go through the
interface.
SSID Enter an SSID.
SSID Broadcast Select to enable or disable the SSID Broadcast.
Security Mode Select a Security mode.
Key/Authentication Enter a key or pre-shared key depending on the Security Mode
selected. For WPA and WPA2 you can also configure the Data
Encryption and Authentication options
Note: You will need to distribute the SSID and key/pre-shared key information with your
wireless users so they can connect to the wireless network.
Note: It is highly recommended you do not select None for the security mode.
Selecting None will leave your wireless network prone to hackers.