Fortinet FortiGate 30E, Информация

Страница: 10 / 16

Cautions and Warnings
Environmental specifications
Refer to specific Product Model Data Sheet for Environmental Specifications
(Operating Temperature, Storage Temperature, Humidity, and Altitude).
Référez à la Fiche Technique de ce produit pour les caractéristiques environne-
mentales (Température de fonctionnement, température de stockage, humidité
et l’altitude).
Safety
Battery – Risk of explosion if the battery is replaced by an incorrect type. Do
not dispose of batteries in a fire. They may explode. Dispose of used batteries
according to your local regulations. IMPORTANT: Switzerland: Annex 4.10 of
SR814.013 applies to batteries.
Batterie – Risque d’explosion si vous remplacez la batterie par un modèle in-
compatible. Jetez les piles usagées selon les réglementations locales en vigueur.
IMPORTANT: Suisse: Annexe 4.10 de SR814.013 s’appliquant aux batteries.
警告
本電池如果更換不正確會有爆炸的危險
請依製造商說明書處理用過之電池
This product is intended to be supplied by a Listed Direct Plug-In Power Unit
marked LPS or Class 2 and rated 12 Vdc, 2 A or
Le produit doit être alimenté par un bloc d’alimentation à courant continu homo-
logué UL de 12 Vdc, 2 A nominal marqué LPS ou Class 2.
Regulatory Compliance
Federal Communication Commission (FCC) – USA
This device complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy,
and if it is not installed and used in accordance with the instruction manual, it
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING : Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate
the equipment
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm
(could be 20 to 30) between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Caution
: Operation of this device is restricted to indoor use only.
Industry Canada Equipment Standard for Digital Equipment
(ICES) – Canada
CAN ICES-3 (B) / NMB-3 (B)
Industry Canada (IC RSS) – Canada
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm
(could be 20 to 30) between the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être installé et
utilisé avec un minimum de 20cm
(could be 20 to 30)
de distance entre la source
de rayonnement et votre corps.
Caution : The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile satellite systems.
High-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interfer-
ence and/or damage to LE-LAN devices.
Attention : Le dispositif de la bande 5150-5250 MHz est réservé à un usage
intérieur afin de réduire l’interférence nuisible potentielle aux systèmes mobiles par
satellite co-canal. Les radars à haute puissance sont désignés comme utilisateurs
principaux (à savoir les utilisateurs prioritaires) des bandes 5250-5350 MHz et
5650-5850 MHz et que ces radars pourraient causer des interférences et / ou
endommager les périphériques LE-LAN
This device has been designed to operate with an antenna having a maximum
gain of 2 dBi for 2.4GHz and 3 dBi for 5GHz. Antenna having a higher gain is
strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.
Under Industry Canada regulations, this radio transmitter may only operate using
an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful commu-
nication.
Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain
maximal de 2 dBi pour 2,4 GHz et 3 dBi pour 5GHz. Une antenne ayant un gain
supérieur sont strictement interdites par la réglementation d’Industrie Canada.
L’impédance d’antenne requise est de 50 ohms.
Conformément à la réglementation d’Industrie Canada, cet émetteur radio peut
fonctionner seulement avec une antenne d’un type et d’un gain maximal (ou
inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire
les risques de brouillage radioélectrique aux autres utilisateurs, il faut choisir
le type d’antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une
communication réussie.