Installation & Initial Configuration
Assigning Virtual Identifiers (VIDs) to protect systems
FortiDDoS v3.2 Installation Guide
28-320-183686-20130401
17
•
These servers/networks may be specific to individual departments, or may be used for
different applications such as web hosting, E-mail or DNS queries.
Your FortiDDoS device is pre-configured to accommodate either 1, 4, or 8 VIDs. Each
VID can be measured against a unique set of threshold parameters that are
independent of other VIDs. This is shown in
configured; you may leave blank those that you do not need.
Figure 12:
Network with FortiDDoS protecting multiple VIDs
Configuring VIDs
To configure a VID:
1
From the main menu, click
Configure > Global > VIDs
2
Simply enter the following information:
• Subnet ID
This ID is used to for subnet-based reporting. Administrator can generate attack
event report for individual subnets.
You can enter up to 512 subnets. Please refer to the datasheet of your
appliance.
• IP Address
This corresponds to the IP address of the subnet you want to add to a VID.
• Netmask
This corresponds to the Netmask of the subnet you want to add to a VID.
Note:
It is recommended that you use a single network switch between the FortiDDoS device
and protected systems. The goal is to avoid inserting any potential source of attack traffic
that does not pass through the device.
Содержание FortiDDoS
Страница 1: ...FortiDDoS v3 2 Installation Guide ...
Страница 37: ......