Fortinet FortiAP S323CR, Информационное руководство

Страница: 6 / 11

Cautions and Warnings
Environmental Specifications
Refer to specific Product Model Data Sheet for Environmental
Specifications (Operating Temperature, Storage Temperature,
Humidity, and Altitude).
Référez à la Fiche Technique de ce produit pour les caractéris-
tiques environnementales (Température de fonctionnement,
température de stockage, humidité et l’altitude).
Safety
Caution: This equipment is to be used in a Network Environ-
ment 0 per IECTR 62101. This product is connected only to
PoE networks without routing to the outside plant.
Attention : Ce matériel doit être utilisé dans un Environnement
Réseau 0 par IECTR 62101. Ce produit est uniquement con-
necté aux réseaux PoE sans installation externe de routage.
This product is intended to be supplied by a Listed Direct Plug-
In Power Unit marked LPS or Class 2 and rated 12 Vdc, 2 A or
by 48 Vdc from PoE source.
Le produit doit être alimenté par un bloc d’alimentation à
courant continu homologué UL de 12 Vdc, 2 A nominal marqué
LPS ou Class 2 ou par une source d’alimentation par Ethernet
de 48 Vdc (PoE).
Regulatory Compliance
Federal Communication Commission (FCC) – USA
This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential
installation. This equipment generates, uses, and can radiate
radio frequency energy, and if it is not installed and used in
accordance with the instruction manual, it may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING : Any changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of 32
cm between the radiator and your body. This transmitter must
not be co-located or operating in conjunction with any other
antenna or transmitter.
Caution : Operation of this device is restricted to indoor use
only.
Industry Canada Equipment Standard for Digital
Equipment (ICES) – Canada
CAN ICES-3 (B) / NMB-3 (B).
Industry Canada (IC RSS) – Canada
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit ac-
cepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance of 32 cm between
the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux ray-
onnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 32 cm
de distance entre la source de rayonnement et votre corps.
Caution : The device for the band 5150-5250 MHz is only for
indoor usage to reduce potential for harmful interference to
co-channel mobile satellite systems. High-power radars are
allocated as primary users (i.e. priority users) of the bands 5250-
5350 MHz and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
Attention : Le dispositif de la bande 5150-5250 MHz est réservé à
un usage intérieur afin de réduire l’interférence nuisible potentielle
aux systèmes mobiles par satellite co-canal. Les radars à haute
puissance sont désignés comme utilisateurs principaux (à savoir
les utilisateurs prioritaires) des bandes 5250-5350 MHz et 5650-
5850 MHz et que ces radars pourraient causer des interférences
et / ou endommager les périphériques LE-LAN
This device has been designed to operate with an antenna
having a maximum gain of 5 dBi for 2.4GHz and 7 dBi for 5GHz.
Antenna having a higher gain is strictly prohibited per regulations
of Industry Canada. The required antenna impedance is 50 ohms.
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
Ce dispositif a été conçu pour fonctionner avec une antenne
ayant un gain maximal de 5 dBi pour 2,4 GHz et 7 dBi pour
5GHz. Une antenne ayant un gain supérieur sont strictement
interdites par la réglementation d’Industrie Canada. L’impédance
d’antenne requise est de 50 ohms.
Conformément à la réglementation d’Industrie Canada, cet
émetteur radio peut fonctionner seulement avec une antenne
d’un type et d’un gain maximal (ou inférieur) approuvé pour
l’émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique aux autres utilisateurs, il faut
choisir le type d’antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire à l’établissement d’une communication réussie.
European Conformity (CE) - EU
This is a Class B product. In a domestic environment, this product
may cause radio interference, in which case the user may be
required to take adequate measures.