Fortinet FortiAP 421E, Информация

Страница: 6 / 11

Cautions and Warnings
Environmental specifications
Ambient operating temperature: 0°C to 45°C
Refer to specific Product Model Data Sheet for Environmental
Specifications (Operating Temperature, Storage Temperature,
Humidity, and Altitude).
Référez à la Fiche Technique de ce produit pour les caractéris-
tiques environnementales (Température de fonctionnement,
température de stockage, humidité et l’altitude).
Safety
Caution: This equipment is to be used in a Network Environment
0 per IECTR 62101. This product is connected only to PoE
networks without routing to the outside plant.
Attention: Ce matériel doit être utilisé dans un Environnement
Réseau 0 par IECTR 62101. Ce produit est uniquement connecté
aux réseaux PoE sans installation externe de routage.
This product is intended to be supplied by a Listed Direct Plug-In
Power Unit marked LPS or Class 2 and rated 12 Vdc, 3 A, Tma =
45°C, or by 48-57 Vdc from PoE source.
Le produit doit être alimenté par un bloc d’alimentation à courant
continu homologué UL de 12 Vdc, 3 A, , Tma = 45°C nominal
marqué LPS ou Class 2 ou par une source d’alimentation par
Ethernet de 48-57 Vdc (PoE).
The connecting cable between the outdoor equipment and the
indoor ITE devices should comply with Class 3 wiring methods as
listed in NEC, Table 725.154(G) for Class 3 Cable Substitutions.
Le câble connectant l’équipement extérieur et ceux d’intérieur
de type ITE doit être conforme avec les méthodes de câblage
de classe 3 tel que listé dans le standard NEC, Table 725.154(G)
pour les câbles de substitutions de classe 3.
This product is intended to be supplied by 48-57Vdc from POE
or by a UL Listed / IEC Certified ITE AC/DC adaptor rated output
12Vdc, 3A, Tma = 45°C, (marked LPS or Class 2).
Ce produit est fourni par la puissance de 48-57VDC alimentation
POE, certifié IEC / UL avec l’émission de 12VDC, 3A, Tma = 45 °
C (Marqué LPS ou classe 2)
PoE input cable type should be CL3, CL3P, CL3R, CL3X, marked
“SUNLIGHT RESISTANT”, “SUN. RES.”, or “SR.” and “water
resistant” or “W”.
Le type de câble PoE d’entrée doit être CL3, CL3P, CL3R, CL3X
marqué “SUNLIGHT RESISTANT”. “SUN RES.» Ou «SR». et
“waterproof” ou “W”.
If further assistance is needed with purchasing a power source
and POE input cable, please contact Fortinet, Inc.
Si vous avez besoin de plus d’aide à l’achat de l’alimentation et le
fil d’entrée PoE, s’il vous plaît communiquer avec Fortinet, Inc.
The Console port is not intended to be connected to the comput-
er after the outdoor installation is completed.
La porte Console n’est pas destinée à être raccordée à l’ordina-
teur après l’installation extérieure faite.
Regulatory Notices
Federal Communication Commission (FCC) – USA
This device complies with Part 15 of FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received; including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in residential installation.
This equipment generates, uses, and can radiate radio frequency
energy, and if it is not installed and used in accordance with the
instruction manual, it may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING: Any changes or modifications to this unit not
expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 31 cm between the
radiator and your body. This transmitter must not be co-located
or operating in conjunction with any other antenna or transmitter.
For operation within 5.15 ~ 5.25GHz, it is restricted to indoor
environment.
This device meets all the other requirements specified in Part 15E,
Section 15.407 of the FCC Rules.
Industry Canada Equipment Standard for
Digital Equipment (ICES) – Canada
CAN ICES-3 (B) / NMB-3 (B)
Industry Canada (IC RSS) – Canada
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit ac-
cepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 37 cm between
the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux ray-
onnements IC établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 37 cm
de distance entre la source de rayonnement et votre corps.
Caution: The device for the band 5150-5250 MHz is only for
indoor usage to reduce potential for harmful interference to
co-channel mobile satellite systems.
Attention: Le dispositif de la bande 5150-5250 MHz est réservé
à un usage intérieur afin de réduire l’interférence nuisible potenti-
elle aux systèmes mobiles par satellite co-canal.
Caution: The maximum antenna gain permitted for devices in
the band 5725-5850 MHz shall be such that the equipment still
complies with the e.i.r.p. limits specified for point-to-point and
non-point-to-point operation as appropriate.
Attention: Le gain maximal d’antenne permis (pour les dispositifs
utilisant la bande de 5725 à 5850 MHz) doit être conforme à la
limite de la p.i.r.e. spécifiée pour l’exploitation point à point et
l’exploitation non point à point, selon le cas.
Caution: Users should also be advised that high-power radars
are allocated as primary users (i.e. priority users) of the bands
5650-5850 MHz and that these radars could cause interference
and/or damage to LE-LAN devices
Attention: De plus, les utilisateurs devraient aussi être avisés
que les utilisateurs de radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les
bandes 5650-5850 MHz et que ces radars pourraient causer du
brouillage et/ou des dommages aux dispositifs LAN-EL.
This radio transmitter (7280B-28166011) has been approved by
Industry Canada to operate with the antenna types listed below
with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this
device.
Le présent émetteur radio (7280B-28166011) a été approuvé par
Industrie Canada pour fonctionner avec les types d’antenne
énumérés ci-dessous et ayant un gain admissible maximal et
l’impédance requise pour chaque type d’antenne. Les types
d’antenne non inclus dans cette liste, ou dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour
l’exploitation de l’émetteur.