18
Hang on a wall
1. Peel off the drill template sticker, and stick it onto the wall in a desired location.
2. Use the template to mark and drill the pilot holes.
3. Insert the anchors into the holes.
4. Insert the screws into the anchors and tighten, leaving around a 5-mm gap between
the screw head and the wall.
5. Position the device so that the mounting holes line up with the screws.
6. Place the mounting slots over the screws and slide the device down until the screws
fit into the slots.
Tip:
Use bear claw screws. The screw heads of bear claw screws have a built-in gap
that fits well with the hanging holes. You can purchase bear claw screws from a
local or online hardware store.
Fasten onto a wall
1. Peel off the drill template sticker, and stick it onto the wall in a desired location.
2. Use the template to mark and drill the pilot holes.
3. Insert the anchors into the holes.
4. Snap off the plastic cover over the LEDs on the front to reveal the long screw holes.
5. Insert the long screws through the device from front to back.
6. Insert the long screws into the anchors on the wall and tighten.
7. Replace the cover over the LEDs on the front. Refer to the illustrations on the next
page.
FortiExtender-511F-QuickStart.indd 18
FortiExtender-511F-QuickStart.indd 18
7/22/2021 6:21:41 PM
7/22/2021 6:21:41 PM
