Fortinet AP400 Series, Руководство по установке

Страница: 61 / 102

Installing AP433i 47
vided in the box) into the unlock hole on the side of the AP shown in Figure 25 on page 46 in
order to clip the AP in place.
Figure 26: Mounting AP433i to a Suspended Ceiling Rail
To mount an AP433i below a suspended ceiling:
1.
Determine the location on the ceiling rail where the AP will be mounted and remove the
ceiling tiles.
2.
Verify that the AP is unlocked using the locking key on the unlock mechanism (on the
same side as the Ethernet ports).
3.
Press the AP433i against the T-bar at a slight angle and then rotate into place, as indi-
cated in
Figure 26 on page 47 . You should hear it snap in place.
4.
Connect one end of the PoE Ethernet cable to the AP’s Ethernet port (see Figure 27 on
page 48 ).
T-bar
(in ceiling)
00261
Be sure to connect the Ethernet cable to the Ethernet port; the cable can mistakenly be plugged into the
Console port. If you do this. the AP won’t power up.