It is recommended that 2 people are involved
in this step. Using a step ladder lift the fan
assembly with the canopy attached, find a
secure place (preferably a joist) and using a
wood screw and washer (not supplied) secure
the safety cable to it. Adjust the slack of the
safety cable using the clamp. Even though
this step is not required in the US, this eases
the installation process.
Gently insert the receiver into the Mounting Bracket with the
flat part towards the top. Carefully push wires and wire
connectors into the electric box leaving the antenna and
connectors outside of the Mounting Bracket.
Spliced conductors should be turned upward and pushed carefully up into outlet
box. The wires should be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet box.
Insert the 3-piece male connector
A
from the Motor Assembly to receiver's
3-piece female connector
A
. Make sure the Red wire aligns with the Red wire,
Brown with Brown and Yellow with Yellow. Then insert the 2-piece male
connector
B
from the Motor Assembly to receiver's 2-piece female connector
B
.
Put the wires back inside the Canopy so that they relaxed.
10
Lift the Motor Assembly aligning the slot with the
screws (one on each side) you left loose in the
Mounting Bracket.
Once they engage twist the Motor Assembly
clockwise.
Insert the two screws you took out in the holes that
should be aligned with the threaded holes in the
Mounting Bracket.
Tighten SECURELY ALL SCREWS. ENSURE that
wires have not been compressed by the Canopy
!
WARNING: Failure to secure
safety cable with solid anchoring
place may result in serious
personal injury or death.
!
WARNING: Failure to secure the
Canopy to the Mounting Bracket may
result in serious personal injury or
death.
Wood Screw
and Washer
Clamp
Safety Cable
Wood Ceiling Joist
Safety Cable Loop
Securing Fan to Bracket, Flush Mount
Go to Page 11 to complete your installation
A
A
B
B
Antenna
