Forney 52765, Руководство пользователя

Страница: 4 / 22

4 WWW.FORNEYIND.COM
5V USB PORT
The USB outlet provides up to 1.1A at 5V DC.
1. Turn the USB switch to the USB position, and the
USB indicator LED will be on;
2. Plug the device into the USB port;
3. Reverse these steps when finished using the USB
port;
4. Recharge the jump starter as soon as possible after
using the USB port.
POWER SUPPLY VIA 12V OUTLET
• Max. output is 15A (180W).
• The outlet has overload protection with automatic
reset.
• The internal battery in the jump starter can be
emergency charged from the vehicle's 12V outlet.
However, it cannot be charged fully in this way. Use
the AC charger in the usual case.
1. Open the cover over the outlet.
2. Connect the 12V product to the outlet.
3. If the output socket of jump starter is overloaded by
output current (15A max), the circuit will be cut off
automatically. Reduce the amp draw of electrical
equipment on the socket and the circuit will be
restored automatically in a few minutes.
4. Recharge the jump starter as soon as possible after
using the output socket
COMPRESSOR
WARNING: The compressor can be run continuously
for maximum 10 minutes and then it needs to cool
down for at least 10 minutes. When inflating tires, the
pressure will rise very quickly - pay attention.
Inflation
1. Open the compressor compartment and pull out
the air hose.
2. Place the nozzle over the valve and press it right
down. Fold down the locking lever into the locked
position.
3. Start the compressor with the compressor power
switch.
4. Monitor the air pressure on the pressure gauge
until the desired pressure is reached.
5. When the desired pressure has been reached, turn
off the compressor with the power switch, fold up
the locking lever and disconnect the nozzle from
the valve. Replace the hose in the compressor
compartment.
6. Use an adapter to inflate beach balls, air
mattresses, inflatable boats etc.
INVERTER
The inverter can supply 120VAC, 60Hz, 200W.
• To protect the battery, the inverter is fitted with
under voltage protection. If the voltage falls too low,
an alarm will be emitted and the inverted will be
switched off. It will be reset automatically when the
battery voltage is higher.
• The inverter is fitted with short-circuit protection,
which switches off the jump starter if the connected
equipment short-circuits.
• If the indicator light on the inverter comes on, check
that the connected equipment is working correctly
and does not need too much power for the jump
starter. Also check the charge level in the battery.
• The fuse trips in the following situations. Replace the
fuse if necessary.
– If the connected equipment needs too much
power.
– In the event of a short circuit in the connected
equipment.
1. Set the inverter power switch to the ON position.
2. Insert the cable from the external equipment into
the 120V outlet.
3. Start the external equipment.
4. The inverter can be switched off automatically or
with the power switch.