12
WWW.FORNEYIND.COM
Description
Your new single phase inverter multi-process welder offers three welding processes in the same power source. These
processes can be selected with the PROCESS SELECTOR BUTTON on the front panel of the unit.
Flux-Cored Wire Welding, “FCAW” and MIG Welding, “GMAW”
The operator is required to set both the wire speed (RIGHT KNOB) and the welding voltage (LEFT KNOB).
Stick Welding, “SMAW”
Both rutile and basic electrodes can be welded. Welding current is adjusted using the LEFT KNOB.
TIG Welding, “GTAW”
In the TIG position, a TIG torch with a gas valve is not required. The internal gas valve automatically opens when foot
pedal or torch trigger is used.
Using the LEFT KNOB, maximum welding current can be adjusted and controlled with pedal or TIG torch.
Welder Layout and Controls
1.
PROCESS SELECTOR BUTTON
to select the welding process selection:
a. CV MIG (“GMAW”)- Constant Voltage.
b. DC TIG LIFT (“GTAW”) – Direct Current TIG automatic start when touch and lifted to create arc.
c. DC STICK (“SMAW”)- Direct Current Stick welding.
2.
THERMAL FAULT LED
thermal overload protection has been activated.
3.
INPUT VOLTAGE LED
will be illuminated when input voltage to the machine is present and the ON/
OFF SWITCH is in the ON position. LED will be green in 230V mode and white in 120V mode.
4.
FAULT/THERMAL OVERLOAD INDICATOR LED
will be illuminated under the following conditions:
a. The duty cycle of the machine has been exceeded or air flow is blocked. The fan will continue to run
until the machine has cooled, but output power will be disabled. Ensure that the cooling fan is running
and that there are 12 inches of clearance around all vents. When the LED turns off, welding power will
be enabled again.
b. The input voltage is outside of the acceptable range. If this indicator remains illuminated for more
than 10 minutes, it is likely that there is an input voltage problem.
c. A fault condition exists. See troubleshooting guide.
5.
RIGHT KNOB
is used to adjust the following welding parameters:
a. In MIG (“GMAW”) Mode it adjusts wire feed speed at 230V from 90- 550 (IPM)/ 120V from 90-
220 (IPM).
b. In STICK (“SMAW”) Mode it is not active.
c. In TIG, (“GTAW”) Mode it is not active.
6.
LEFT KNOB
is used to adjust the following welding parameters:
a. In MIG (“GMAW”) Mode it adjusts arc voltage at 230V from 13.0-25.0 / 120V from 13.0-20.0.
b. In STICK (“SMAW”) Mode it adjusts welding current (amperage) at 230V from 10.0-200 / 120V
from 10.0-75.0.
c. In TIG, (“GTAW”) Mode it adjusts welding current (amperage) at 230V from 10.0-200.0 / 120V
from 10.0-110.0.
7.
EURO CONNECT SOCKET FOR MIG TORCH
8.
MIG ELECTRODE POLARITY JUMPER
9.
ACCESSORY SOCKET
plug for the pedal, amptrol or TIG torch (unit will recognize accessory)
10.
NEGATIVE (-) DINSE SOCKET 35/50
11.
TIG GAS OUTPUT
12.
POSITIVE (+) DINSE SOCKET 35/50
13.
POWER SWITCH
14.
TIG GAS INPUT
Getting to Know Your Multi-Process Welder
