Fornelli PIA 60 MERIDIANA, Руководство пользователя

Страница: 23 / 32

Installation and Operating Manual Installation and Operating Manual
HOBS
21
INSTALLING
THE GLASS-CERAMIC HOB
WARNING!
The hob must be installed by qualified
personnel only.
The hob must be installed in proper man-
ner in strict conformity with the regula-
tions of local electricity supplier and ap-
plicable standards.
During the entire process of installation
the hob must be disconnected from mains.
The hob must be installed so as to ensure
protection against accidental contact with
the details under voltage.
The surface used for building in the hob,
must withstand 100°C.
In the event that a built-in oven or any oth-
er appliance, which becomes hot during
operation. are installed beneath the hob
and its control panel, it is required to en-
sure, that the temperature in close proxim-
ity to the control panel of the hob will not
exceed 60°C. To this end 40 mm gap must
be provided between the bottom of the
hob and the appliance installed beneath
the hob (see Figure 9).
The gap between the bottom of the hob and
the shelf of the kitchen furniture, which is the
closest to the hob, must be at least 25 mm.
INSTALLATION
Cut out an opening with the dimensions, as
shown in Figure below, In the countertop, into
which you are going to install the hob.
Ensure that along the entire perimeter of the
opening there is a strip of free space of at
least 5 cm width.
Make sure, that the countertop thickness is
at least 35 mm. Please, to avoid significant
deformations, caused by the heat, emitted
by the hob, choose countertops with heat-
resistant coatings:
560
520
487
55
490
590
557
56
50 mi
n
50 mi
n
In all circumstances the induction hob must
be well ventilated, the air output of the hob
must be free from any obstacles. Make sure,
that induction hob is in proper and good
condition.
NOTE : safe distance between the hob and
the kitchen furniture item beneath the hob
must be at least 760 mm.
A larger scale drawing
is given on Page 26 below