Formula 48 2008, Руководство пользователя

Страница: 54 / 132

5-12
Section 5
Single Point Water Fill Systems
Figure 5-13
Hot Water Heater — Formula equips some
models with an on-board water heater, which
operates on 110V AC power. To operate the water
heater, the AC/DC panel must be supplied with
110V power and the AC panel switch labeled
WATER HEATER must be ON. To avoid damaging
the water heater element, the water heater tank
must be full before turning the unit ON.
NOTICE
A “passive” means for heating onboard
water is accomplished via plumbing
between the engines and the water
heater. Whenever the engines are
operated, water contained within the
water heater will be heated by circulating
engine coolant. Refer to your Formula
Owner Information Binder for specific
instructions and information pertaining to
this accessory as described in the
manufacturer’s literature.
Water heaters unused for more than two weeks
may produce hydrogen gas. To reduce the risk of
injury under these conditions, open the hot water
faucet for several minutes at the galley sink
before you use any electrical appliance
connected to the hot water system.
If hydrogen is present, you probably will hear
unusual sounds like air escaping through the
pipe as water begins to flow. Allow the water to
flow until these sounds disappear.
Do not smoke or have any flame near an
open faucet; hydrogen gas is extremely
flammable.
FOR4 8 -016
FILL
WASTE
DISCHARGE
MID
FULL
LOW
EMPTY
MID
FULL
LOW
EMPTY
WATER
AUTOMATIC
TANK FILL
CITY WATER
WATER PUMP
48 PY/45 PY (optional)
●
Pull the fresh water hose from the transom
of the boat (use the button at the top right of
the hose outlet to retract the hose).
●
Attach the water hose to the dockside water
supply.
●
Turn the dockside supply ON.
ALL
●
Turn the selection switch (Figure 5-13) to
the center position. The water system is
now ready to use with the dockside source
supplying the pressure.
●
Depress the top of the selection switch to fill
the onboard fresh water holding tank. A
solenoid will open, allowing the dockside
source to fill the tank. When the tank is full,
the solenoid will automatically close, to
prevent overfilling the tank.
●
Press the bottom of the selector switch to
use the onboard water supply and pump.
The solenoid will close and the 12V DC
pump will automatically pressurize the
system and deliver water from the onboard
tank.
Freshwater Dockside Hookup – 48 PY
Figure 5-12
FOR4 8 -074