manualshive.com logo in svg

Forms+Surfaces HELIO BOLLARD, Инструкции по установке/подключению, Страница: 2 / 4

Поделиться
Скачать
Forms+Surfaces HELIO BOLLARD Скачать руководство пользователя страница 2

HELIO

™

 BOLLARD

SURFACE MOUNT WITH J-BOLTS INSTALLATION & WIRING INSTRUCTIONS

page 2 of 4  |  Rev. 05-25-21

© 2021 Forms+Surfaces®  |  All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.

T 800.451.0410  |  www.forms-surfaces.com

Tighten nuts

• Use 3/4" socket and socket wrench to 
   tighten all nuts until snug.
 

STEP BY STEP

FOR ALL SURFACE MOUNT HELIO BOLLARDS

Slide base onto J-bolt anchors

• Slide base base plate over J-bolt 
   anchors and lower base to concrete 
   level.

  

Attach base

• Slide 1/2" washer (b), then thread 1/2"-
   13 nut (c) onto each J-bolt anchor.
 

b

c

Содержание HELIO BOLLARD

Страница 1: ... 2 13 x 18 galvanized steel J bolt anchors a into concrete Use template to position J bolt anchors in proper locations Tops of J bolt anchors must be a minimum of 1 1 4 above concrete surface Allow concrete to set completely in accordance with concrete manufacturer s instructions before moving to step 3 FOR ALL SURFACE MOUNT HELIO BOLLARDS a socket wrench 3 4 socket c b a template upon request a e...

Страница 2: ...rsion of this document please refer to our website at www forms surfaces com T 800 451 0410 www forms surfaces com Tighten nuts Use 3 4 socket and socket wrench to tighten all nuts until snug STEP BY STEP FOR ALL SURFACE MOUNT HELIO BOLLARDS Slide base onto J bolt anchors Slide base base plate over J bolt anchors and lower base to concrete level Attach base Slide 1 2 washer b then thread 1 2 13 nu...

Страница 3: ...e color codes from junction box to bollard Tighten wire nuts until exposed wire ends are below bottom of wire nut Inspect all wiring and connections before Caution Light fixture rated for 120 277 VAC power Locate and prepare wires Note Installation should be performed only by qualified individuals Before proceeding with wiring of luminary check to ensure that all applicable site wiring and safety ...

Страница 4: ...without notice For the most current version of this document please refer to our website at www forms surfaces com T 800 451 0410 www forms surfaces com Attach bollard to base plate Thread 5 16 18x1 tamper resistant flat head screws d into each hole Use provided T40 Torx bit for tamper resistant screws to tighten all screws until snug STEP BY STEP FOR ALL SURFACE MOUNT HELIO BOLLARDS d d 10 ...

Отзывы:

Нет отзывов