9
8
APTOS
™
PEDESTRIAN
SURFACE MOUNT INSTALLATION & WIRING INSTRUCTIONS
page 3 of 5 | 12-08-20
© 2020 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Position & attach pole
• Slide base plate over J-bolt anchors and
lower pole to concrete level. Keep pole
supported until attached and tightened.
STEP BY STEP
FOR ALL APTOS PEDESTRIAN LIGHTING
Attach and tighten washers and nuts
• Slide 3/4" washer (b), then thread 3/4"-
10 nut (c) onto each J-bolt anchor.
• Use 1-1/8" socket and socket wrench to
tighten all nuts until snug.
Attach base covers
• Place the four base plate covers in
position and thread 8-32 x 1/2" button
head cap screw (d) into each end hole
and tighten with 5/32" security hex bit.
c
b
c
b
d
d
7
