Manual - Formech FLB1000
3
Safety
Thank you for choosing Formech.
Please read and follow the below safety instructions before attempting
to install or operate your machine.
• Do not operate the machine until you have been trained and are fully conversant with it.
• Read and understand all of the user manual.
• Check your supply voltage and frequency. Make sure it is compatible with your machine. Your machine's
electrical specifi cation is on the plate at the rear of the machine.
• You must ensure that the machine is properly earthed and fused.
If your machine is not equipped with a moulded mains connector then note the below:
• The earth wire is GREEN with a YELLOW stripe.
• The live wire is BROWN
• The neutral wire is BLUE
• Only suitably qualifi ed personnel should make electrical connections
• Turn off the machine and disconnect the power supply when the machine is not in use.
• The heater on this model is not intended to be left running indefi nitely.
• Never remove any panels unless the electrical supply has been isolated.
• Note the safety warnings situated on the top panels.
• Only use the machine for bending plastic sheet. It is not intended for any other purpose.
• Ensure that the area you are working in is properly ventilated and that you are aware of the potential
hazards from the plastics you are forming. It is the responsibility of the owner or designated responsible
person to assess the risks associated with any dangerous fumes given off and to determine any necessary
precautions required such as fume extraction. Contact your plastics supplier to gain information regarding
hazardous fumes.
• Always let the machine cool down before attempting to remove any panels. Some parts of the heater and
heat shield become extremely hot during operation.
• There is a risk of being burnt when handling heated plastics. Always wear suitable personal protective
equipment such as gloves.
• Ensure that the area surrounding the machine is clean and frequently cleared of fi nished product and any
scrap.
• Users of this machine should complete regular competence tests.
