17
Electronic
information
products
poisonous
and
harmful
material
statements
Parts
Poisonous
and
harmful
substances
or
elements
Pb
Hg
Cd
Cr^6+
PBB
PBDE
Phone
X
0
0
0
0
0
Battery
X
0
0
0
0
0
Accessories
X
0
0
0
0
0
In
this
table,
0
means
that
the
poisonous
and
harmful
material
in
the
part
of
all
homogeneous
material
content
are
within
limits
of
SJ/T
11363
‐
2006
standard
requirement.
X
means
that
the
poisonous
and
harmful
material
in
the
parts
of
at
least
homogeneous
materials
beyond
the
content
SJ/T
11363
‐
2006
standard
requirement
prescribed
limits.
Note:
this
product
is
labeled
"X"
because
there
exists
no
alternative
technologies
or
components
at
present.
FCC Caution.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
