Formax FD 8802 series, Инструкция по эксплуатации

Страница: 15 / 26

EvenFlow Oiler Installation (optional) Oiler Installation (optional)
Remove both side covers and top case (fi g. 1
& 2).
Position EvenFlow
TM
Oiler over pre-drilled
holes on top of cutter head, and secure using
the four (4) thumbscrews provided (fi g. 3 & 4).
Push blue tubing into the quick connect end
of the EvenFlow
TM
Oiler and attach to the
underside of frame using supplied cable-tie
mounting bases (fi g. 4).
Feed tubing through slot under loading tray
(same location where safety bar cable runs
through front of unit) and through hole in right
loading table support bracket (fi g. 5).
Mount EvenFlow
TM
Oiler pump to the right
loading table support bracket, matching up
the four (4) pre-drilled mounting holes, using
the supplied screws (fi g. 6).
Insert tubing into quick connect fi tting on
pump and fi ll pump with oil. Pump handle
back and forth several times to introduce oil
into the system and remove air from the line.
Once oil appears from nozzles, check for
any leaks at all hose and fi tting locations and
tighten if needed (fi g. 6).
The brass oiler nozzles (fi g. 3) can be po-
sitioned using slight pressure. Position the
nozzles so they are between the guide plates.
This allows the oil to be applied directly to the
cutting blades.
(**NOTE: Extreme force can crack or break
the brass nozzles. Always use caution when
re-positioning.**)
Re-attach top case and side covers.
1.
2.
3.
4.
5.
6.
7.
8.
Fig. 1 Right Side
Fig. 6
Fig. 5
Fig. 4
Fig. 3
Fig. 2 Left Side
Top Case
Thumbscrews
Quick connect
Blue tubing
Quick connect
Brass
nozzles
Mounting
screws
Mounting
screws
11