FORM FIT
HOOD PROTECTOR
Volkswagen Jetta 2006- / Rabbit 2007-
HD 21H 06
HARDWARE KIT
TOOLS REQUIRED
5 – Large Bumpons
1 – Phillips Screwdriver # 2
4 – Clip Bodies
1 – Tape Measure
4 – 3M Anti-Abrasion Film Pads
4 – ‘L’ Brackets
4 – Pins
4 – # 6 x 5/8” Truss Head Screws
1.
Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it.
2.
Install the bumpons as shown in
Illustration #1
.
Attention: The bumpons must be installed on the hood, not on the protector!!!
If the
bumpons are installed on the protector, they will wear through the paint.
3.
Center the protector on the hood, rest it on the bumpons.
See Illustrations #2.
4.
With protector centered on the hood, peel and fold an anti-abrasion film pad in half over the edge of the hood, underneath each of the two (2)
inner holes in the protector.
See Illustrations #2& #3 – Step #4.
5. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in
Illustration #3 – Step #5a
.
b) Insert a pin through the protector into each of the clips.
See Illustration #3 – Step #5b.
c) Insert a #6 x 5/8’’ screw through an ‘L’- bracket and into the clip.
See Illustration #3 – Step #5c & 5d.
d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips.
6.
Repeat steps #4 and #5 for the other two (2) holes.
7.
On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
Note: Do not pull on the protector when opening or closing the hood.
CARE INSTRUCTIONS
Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents
. Periodically check
to make sure the bumpons are in place and the protector is secure.
Avoid using automatic car washes
. Do not pull on protector when
opening or closing the hood.
Illustration #1 – Bumpon Placement
Illustration #2 – Clip Location
Clips (Steps #4 & #5)
Clips (Step #6)
Illustration #3 – Clip Configuration – Patent No. : 6,892,427
Thank you for purchasing a form fit hood protector. Retain this sheet for care instructions and kit information
Made in Canada
Rev3.100920
Step #4
Step #5a
Step #5b
Step #5c & 5d
3 ½”
14”
4”
½”
6”
