FORM FIT
HOOD PROTECTOR
Toyota Highlander 2011 -
HD 20Q 11
Hardware Kit
Tools Required
4 – Push Type retainers
2 – #6 x 5/8” Flat Head Screws
1 – Phillips Screwdriver #2
2 – Type A Metal Brackets
2 – Clip Bodies
1 – Tape Measure
2 – Type B Metal Brackets
2 – Pins
7 – 3M Anti-Abrasion Film Pad
2 – ‘L’ Brackets
5 – Large Bumpons 4 – Square Expansion Plugs
4 – #8 x 7/16” Truss Head Screws
Installation
1.
Be sure that the hood is clean and dry inside and out.
2.
Install the five (5) bumpons as shown in Illustration.
Attention: The bumpons must be installed on the hood not on the protector!!!
If the bumpons
are installed on the protector, they will wear through the paint.
310mm
310mm
130mm 130mm
65mm
3.
Open the hood of the vehicle. Peel and fold an anti-abrasion film pad in half over the edge of the hood, in the four (4) locations shown in illustration.
Center the film pads with holes identified in the illustration.
4.
Insert the square expansion plugs into the holes identified in the illustration.
Looking at underside of the hood
Anti-abrasion Pads and Metal Brackets Location
Type B Type B
Type A
Type A
5.
NOTE: Use the metal Brackets Guide
to determine the type of bracket used in the following steps.
See Illustration.
Metal Brackets Guide
Type B
Type A – Marked with dot
*
NOTE:
There is a slight variation in the angle of the Bottom leg of the Brackets.
*
Type A Brackets
marked with dot on lower leg.
