HD 13B13 Rev0 Dec 22, 2017 3 of 8
8.
Remove the protective backing film from each of the
adhesive pedestals and install them on the hood surface.
Tip:
Hook the fingers on the pedestal over the hood edge and
rotate the unit into position. After installation, remove the
masking tape and “wet out” the pedestal base by applying
pressure with your thumb around the surface of the
pedestals.
9.
Start a #6 x 5/8 flat head screw into each pedestal a few
turns. The tip of the screw must not protrude into the hole
where the attachment pin will install later.
10. Peel and fold the small anti abrasion film pad in half over the
hood edge between the fingers on each of the pedestals.
11. Push a metal mounting bracket over the hood edge on top of
the anti abrasion pad installed previously. Ensure the
bracket is fully engaged over the hood edge and the hole in
the bracket is aligned with the hole in each of the pedestals.
12. Place the deflector on the pedestals and drop a pin through
the deflector and into the pedestal.
13. Maintain slight pressure on the pin, to ensure proper seating
of the components, while simultaneously tightening the
screw on all of the adhesive pedestals.
NOTE: Only tighten screw a few turns so that the pin is held
in but there is some movement of the deflector. This helps
with the installation of the components above the headlights.
