2
Safety Instruction:
WARNING:
To reduce the risk of fire or electric shock, do not expose the equipment to rain or
moisture. Form Factor Audio assumes no
responsibility for any damage or injury that results from improper use or
service.
CAUTION:
RISK OF ELECTRICAL SHOCK!
This is a high voltage device, and internal voltages
can be lethal. Any work should be performed by qualified personnel only.
Instructions for safe use:
1. Read all instructions provided by factory.
2. Follow all instructions provided by factory.
3. Do not use this unit near water.
4. This unit may cause permanent hearing loss. Do not operate for long periods of time at any
level that is uncomfortable.
5. Clean the unit only with a dry cloth.
6. Do not block any ventilation openings. Make sure nothing interferes with the ventilation of the
unit when in use.
7. The unit should be located away from heat sources such as radiators, heat registers, or other
units that produce heat.
8.
Attention! Liquids must not enter into the enclosure through ventilation openings.
9. Use the Power Cord provided by the factory with a grounding type plug with two blades and a
third grounding prong. If the provided plug does not fit into your outlet, consult an electrician
for replacement of the obsolete outlet. Protect the power cord from being stepped on or pinched
particularly at plugs. Only use attachments/accessories specified by the manufacturer.
10. Unplug the unit during lightning storms or when unused for long periods of time.
11. The unit should be serviced by qualified personnel when the power supply cord or the plug has
been damaged, or devise have fallen, or liquid has been spilled into the unit or unit has been
exposed to rain or moisture, or the unit does not appear to operate normally or exhibits a
marked change in performance.
12. Always insure the amplifier is properly grounded. Always unplug the AC power cord before
performing ANY service, and use only the same type and rating when replacing fuse.
13. To avoid damaging your speakers turn off the amplifier power before connecting instrument.
14. Do not use excessive force when handling buttons, switches and controls.
15. Always connect to an AC power supply that meets the power supply specifications listed on the
rear of the unit.
Export units
: always insure unit is wired for proper voltage. Make certain
grounding conforms with local standards.