PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
60
MM
SCREWS
5
1a
FLOOR & PANEL LAYOUT
1c
APEX SECTIONS
1b
SIDE PANELS
Position and butt the floors together
in your
desired location. Use your section layout on
page 4, which shows the amount of floors for
your chosen shed.
Layout the panels
around your shed base.
We recommend to start in a back corner then
work from the back panels to the front
panels for assembly.
Attach the first Apex Section
to the back
panels by screwing to the wall panels as shown
below.
Attach the other Apex Section
to the front
panels by screwing to the wall panels as shown
below.
Start at a back corner.
See the section layout
on page 4 to confirm position. Secure the
corner as shown below.
Repeat the process for the remaining panels
and
secure
the
panels together.
Make sure
that the bottom frame of the wall panel rests
on the outer edge of the floor.
Secure the panels into place by
screwing into
the floor bearers.
EG. INSIDE CORNER
SIDE PANEL
BACK PANEL
EG. BACK PANELS
APEX SECTION
EG. INTO FLOOR BEARERS
APEX SECTION
Use the same process if you have a reverse
apex shed.
Attach the Apex Sections
to the
side panels by screwing to the wall panels as
shown below.
