Ford wsg-1068, Руководство оператора, Страница: 12 / 46

SERVICE LITERATURE
A service manual can be purchased from your EDI distributor. This publication will provide the
necessary servicing and overhaul information for your Ford Power Products engine.
•
WSG1068 SERVICE MANUAL - EDI
• WSG1068 PARTS LIST - EDI
BEFORE OPERATING THE ENGINE
1. Before operating a new engine it should be thoroughly inspected to ensure that during
transit and installation it has not suffered damage likely to affect its subsequent operation.
Controls and instruments should be studied carefully in order that their functions are
thoroughly understood.
2. Check that the radiator (where applicable) is full and top off as necessary -- Refer to
“Cooling System” on page 28 for recommended coolant mixtures.
3. In the case of marine/industrial engines, ensure that there is coolant in the degas/expansion
tank (where applicable).
CAUTION: Under no circumstances may the engine be started without liquid in the cooling
system.
4. Check the engine oil level and top up or fill as necessary -- Refer to “Check Engine Oil
Level” on page 23. For the correct type and grade of oil -- Refer to “Recommended
Lubricants” on page 21.
5. Ensure that the battery is fully charged and, if necessary, top up with distilled water.
NOTE:
Ensure that ALL wiring ground connections are properly made to a clean point on the
chassis/frame.
6. The engine must be started in accordance with the starting instructions -- Refer
to “STARTING THE ENGINE” on page 17.
OPERATING CONTROLS
Ignition or Isolation Switch
An ignition or isolation switch is usually fitted which connects the engine starter motor and other
electrical equipment to the battery. The switch can be moved to any of the four positions shown by
rotating the key. These positions are: