Ford TOURNEO CONNECT, Руководство пользователя

Страница: 319 / 437

·
Add a suitable antifreeze agent to the
washer fluid if necessary.
NOTICE
Mixing cleaning agents incorrectly can
cause the ingredients to separate and
block the washer jets.
·
Never use unsuitable cleaning agents.
Engine oil
Introduction
Engine oils are matched to the require-
ments of the engines, the emission purifi-
cation systems, and the fuel quality. Due to
the operating principle of combustion en-
gines, engine oil always comes into contact
with combustion residues and fuel, which
has corresponding
effects on the ageing
process of the engine oil. The correct en-
gine oil is important for the function and
service life of the engine. A special multi-
grade high-lubricity oil has been
filled at
the factory and this can normally be used
as an all-season oil.
Information on warning and indicator
lamps that light up can be found in the
troubleshooting sections at the end of the
chapter
→
page 320.
WARNING
Incorrect handling of engine oil can cause
serious burns and other injuries.
·
Always wear eye protection when han-
dling engine oil.
·
Engine oil is toxic. Always keep engine
oil out of the reach of children.
·
Store engine oil only in the closed origi-
nal container. This also applies to used
oil until it is disposed of.
·
Regular contact with engine oil can
damage the skin. Always wash skin that
has been in contact with engine oil
thoroughly with water and soap.
·
Engine oil becomes extremely hot when
the engine is running and can scald skin
severely. Always allow the engine to
cool down.
Leaking or spilt engine oil can pollute
the environment. Collect any service
fluids that escape or are spilled and dis-
pose of them correctly and with respect for
the environment.
Engine oil standards
Please refer to , and on page
312 and at the start of the chapter on
page 317.
Use oils and fluids in accordance with the
designated specifications and viscosities.
— Standard WSS–M2C956–A1, viscosity
SAE 0 W–20.
Using oils and fluids that do not meet the
designated specifications and viscosities
may result in the following:
— Damage to components not covered by
the vehicle warranty.
— Prolonged engine start-up phases.
— Increased emission values.
— Reduced engine power.
— Increased fuel consumption.
— Reduced braking performance.
If no engine oil of
specification WSS-
M2C956-A1 is available, SAE 0 W-30 en-
gine oil as per ACEA C3 can be used for re-
filling
→
.
Please note that you should not add more
than 0.5 l (0.5 qt) of alternative engine oil
between scheduled inspection intervals
→
.
NOTICE
The use of approved engine oils in accord-
ance with the relevant standard is recom-
mended. The use of engine oils that do not
meet these quality requirements can cause
engine damage.
Engine oil 317
2KF012
720AB