Ford TOURNEO CONNECT, Руководство пользователя, Страница: 300 / 437

3. Pull the rubber cover
→
Fig. 171
1
off
the back of the headlight.
4. Turn the bulb holder
→ Fig. 172
1
in the
direction of the arrow as far as it will go
and pull it out to the rear.
5. Replace the defective bulb with a new
bulb of the same type. If applicable,
push the catch on the bulb holder and
pull the bulb straight out of the bulb
holder.
6. Insert the bulb holder
→ Fig. 172
1
into
the headlight and turn it in the opposite
direction to the arrow as far as it will go.
7. Fit the rubber cover
→
Fig. 171
1
to the
back of the headlight.
8. Close the bonnet.
Changing a bulb for low beam head-
lights
The actions should only be carried out in
the
specified order:
1. Observe and follow the instructions in
the checklist
→
page 296.
2. Open the bonnet.
3. Pull the rubber cover
→
Fig. 171
2
off
the back of the headlight.
4. Pull the bulb holder out
→ Fig. 172
2
in
the direction of the arrow.
5. Replace the defective bulb with a new
bulb of the same type. If applicable,
push the catch on the bulb holder and
pull the bulb straight out of the bulb
holder.
6. Insert the bulb holder
→
Fig. 172
2
into
the headlight and press in the opposite
direction to the arrow.
7. Fit the rubber cover
→
Fig. 171
2
to the
back of the headlight.
8. Close the bonnet.
Changing a bulb for turn signal
The actions should only be carried out in
the
specified order:
1. Observe and follow the instructions in
the checklist → page 296.
2. Open the bonnet.
3. Turn the bulb holder
→
Fig. 172
3
in the
direction of the arrow as far as it will go
and pull it out to the rear.
4. Replace the defective bulb with a new
bulb of the same type. If applicable,
push the catch on the bulb holder and
pull the bulb straight out of the bulb
holder.
5. Insert the bulb holder
→
Fig. 172
3
into
the headlight and turn it in the opposite
direction to the arrow as far as it will go.
6. Close the bonnet.
Changing bulbs in the tail light
cluster
Please refer to and at the start
of the chapter on page 295.
Removing a tail light cluster
Fig. 173 At the rear left side of the vehicle:
removing the bulb body.
1
Screw.
2 Auxiliary tool.
The actions should only be carried out in
the
specified order:
1. Observe and follow the instructions in
the checklist → page 296.
2. Open the boot lid.
3. Take the vehicle toolkit out of the stow-
age area.
4. Undo three screws with a screwdriver
→
Fig. 173
1
. Insert a suitable inter-
changeable blade if necessary.
298 If and when