All 2005 to Present Model Year Ford/Mercury/Lincoln Vehicles With Keyless Remote Entry System
INSTALLATION
RF Keypad
ALL 2005 TO PRESENT MODEL YEAR FORD/MERCURY/LINCOLN VEHICLES WITH
KEYLESS REMOTE ENTRY SYSTEM
1. Please read ALL of these instructions before proceeding.
A. Program the RF Keypad to Your Vehicle
NOTE:
It is easier to program the keypad prior to attaching it to the vehicle.
After five seconds of idle time, the keypad will reset itself.
NOTE:
You must have all remote entry transmitters available before beginning this procedure, Fobs and RF
keypads. Check owners guide ‘‘Locks and Security’’ for maximum remote entry transmitters allowed, and
proper key positions.
If all remote entry transmitters are not present during the programming procedure, the missing
transmitters will not work following programming.
NOTE:
The vehicle will exit programming mode after 20 seconds of inactivity.
NOTE:
Ensure the brake pedal is not depressed during this procedure; the electronic signal could interfere with
programming.
Focus 2007 and Earlier Model Years
(For all other vehicles proceed to “All Other Vehicles”)
2. Make sure that you have all of the Fobs and RF keypads for this vehicle.
3. Insert a key in the ignition.
4. Turn the key from the OFF position to the RUN (not START) position four times within six
seconds.
The fourth turn must end in the OFF position
The system will chime to confirm the vehicle is in programming mode.
5. Within 20 seconds of completing the previous step, press any button on Fob 1, if equipped.
The system will chime once, to confirm that the Fob has been programmed.
6. Within 20 seconds of completing the previous step, press any button on Fob 2, if equipped.
The system will chime once, to confirm that the Fob has been programmed.
7. Within 20 seconds of completing the previous step, press the 7/8 and 9/0 buttons simultaneously
on the RF keypad 1.
The system will chime once, to confirm that the RF keypad has been programmed.
Repeat this step if more than one RF keypad is used
.
8. After all remote entry transmitters have been programmed; turn the ignition to the RUN position
for the vehicle to exit programming mode.
Page 1 of 4
SK7L2J - 19G544 – AA
© Ford 2007 FoMoCo
