Ford Ranger 2020, Руководство по монтажу, Страница: 59 / 94

4.3 Parking Aid
WARNINGS:
To help avoid personal injury, always use
caution when in reverse (R) and when
using the sensing system.
The system may not detect objects with
surfaces that absorb reflection. Always
drive with due care and attention. Failure
to take care may result in a crash.
Traffic control systems, inclement
weather, air brakes, external motors and
fans may affect the correct operation of
the sensing system. This may cause
reduced performance or false alerts.
The system may not detect small or
moving objects, particularly those close
to the ground.
NOTE: Keep the sensors, located on the bumper
or fascia, free from snow, ice and large
accumulations of dirt. If the sensors are covered,
the system’s accuracy can be affected. Do not
clean the sensors with sharp objects
NOTE: If your vehicle sustains damage to the
bumper or fascia, leaving it misaligned or bent,
the sensing zone may be altered causing
inaccurate measurement of obstacles or false
alerts.
NOTE: Certain add-on devices installed around
the bumper or fascia may create false alerts. For
example, large trailer hitches, bike or surfboard
racks, license plate brackets, bumper covers or
any other device that may block the normal
detection zone of the system. Remove the add-on
device to prevent false alerts
The parking aid sensing system warns the driver
of obstacles within a certain range of your vehicle.
The system turns on automatically whenever you
switch the ignition on. The system can be
switched off through the information display
menu or from the pop-up message that appears
once you shift the transmission into reverse (R).
If a fault is present in the system, a warning
message appears in the information display. See
the vehicle owner manual for further information
on the correct operation of the parking aid system.
Protection assemblies mounted on the front of
the vehicle, such as Bull Bars/Nudge Bars and
frontal crash and animal strike protection
assemblies may require that the front parking aid
sensors are relocated to a different position than
the original Ford positioning. The below guidelines
and details should be followed to maintain
suitable operation of the parking aid system by
ensuring the sensor detection angles are
maintained in a suitable specification.
Where possible, front parking aid sensors should
not be moved from the original positions on the
X, Y and Z plane. Maintaining the sensors location
on these planes is important for correct operation
of the system.
Date of Publication: 09/2020
FORD RANGER 2020
4 El
ec
tric
al
59