1/29/2020
Anti-Theft - Passive Anti-Theft System (PATS) - MyKey® Programming - General Procedures • 2012 Ford F-150 • MotoLogic
https://www.motologic.com/car/2012_fd_f-150_4716/article/726d26f798630fd01e8ba900fd66fe86?returnPath=%2Fcar%2F2012_fd_f-150_4716%2Fs…
3/4
NOTE: The following features can be restricted on a MyKey®:
audio volume level set to a pre-determined level (45% of the maximum volume)
maximum speed limit of 130 km/h (80 mph) on or off
speed alert chimes set for 75, or 90 or 105 km/h (45, or 55 or 65 mph)
AdvanceTrac® always on feature turned on or off
1. Insert an admin key into the ignition and turn the key to the RUN position.
2. From the message center main menu, use the up and down arrow buttons to scroll to and select Settings. Press the
OK button.
3. Use the up and down arrow buttons to scroll to and select MyKey. Press the OK button.
4. Use the up and down arrow buttons to scroll to and select AdvanceTrac. Press the OK button.
5. Use the left and right arrow buttons to configure the AdvanceTrac® to be automatically locked on or able to be
turned on or off by the MyKey® driver. Press the OK button.
6. Repeat steps 4 and 5 for the next features:
MAX MPH: 80 MPH or OFF
Speed Warning: 45 55 or 65 MPH (choose the desired speed for the chime to sound)
Volume Limiter ON or OFF (choose the audio volume to be limited to 45%)
Clear MyKey®
With Base Message Center
1.
NOTE: This procedure is used to clear the MyKey® feature on all of the keys that are programmed to the vehicle. All
of the keys then operate as normal (admin) keys with no restrictions.
Insert an admin key into the ignition and turn the key to the RUN position.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY is displayed.
3. Press and release the RESET button until HOLD RESET TO CONFIRM CLEAR is displayed.
4. Press and hold the RESET button until ALL MYKEYS CLEARED is displayed.
A MyKey® can also be cleared during the same key cycle that it was programmed by following Steps 2, 3
and 4 of this procedure.
With Optional Message Center
1.
NOTE: This procedure is used to clear the MyKey® feature on all of the keys that are programmed to the vehicle. All
of the keys then operate as normal (admin) keys with no restrictions.
Insert an admin key into the ignition and turn the key to the RUN position.
2. From the message center main menu, use the up and down arrow buttons to scroll to and select Settings. Press the
OK button.
3. Use the up and down arrow buttons to scroll to and select MyKey. Press the OK button.
