FX1-50-14.4V-1500MAH-2B
EN
Copyright © 2015
P a g e
|
9
www.Ford-tools.com
NOTE:
If the battery does not fit properly, disconnect it and confirm that the
battery pack is the correct model for this charger as shown on the specification
chart. Do not charge any other battery pack or any battery pack that does not
securely fit the charger.
1.
Frequently monitor the charger and battery pack while connected.
2.
Unplug the charger and disconnect it from the battery pack when finished.
3.
Allow the battery pack to cool completely before using it.
4.
Store the charger and battery pack indoors, out of reach of children.
NOTE:
If battery is hot after continuous use in the tool, allow it to cool down to
room temperature before charging. This will extend the life of your batteries.
7.3
Removal / insertion of battery (Fig. 3)
Fig. 3
WARNING:
1.
Before making any adjustments ensure the drill is switched off with the
reversing switch in the center position.
2. Hold the drill with one hand and the battery pack (9) with the other.
3.
To install:
pull and slide battery pack into battery port, make sure the latch (10)
on the front side of the battery snap into place and battery is secure before begging
operation.
4.
To remove:
use your thumb and fingers, press the battery release latch in and
pull the battery pack off at the same time.
