
FX1-120
EN
Copyright © 2015
P a g e
|
8
www.Ford-tools.com
Locate the depth stop (4) on the left-hand side of the cutting machine. This
continuously adjustable stop is intended to limit the depth of the cut. Loosen it by
turning it in anticlockwise direction. To move the depth stop up or down to the
desired depth according to the marker of the scale label (3).
NOTE: Make sure the locking knob (10) is fixed firmly when
operating this machine.
7.3
Locking lever (13) for cutting machine body
When viewed from the front, the locking lever is located at the rear on the left-
hand side. The cutting machine body is spring-tensioned. Take care when
releasing the locking lever. Grasp both handles and brace yourself before
releasing the lever. Press downwards to allow the cutting machine body to move
down. When you reduce the downward pressure, the springs force the cutting
machine body back up into its highest position.
The released position (a) or lock position (b) of locking lever as shown in Fig. 3.
CAUTION: The housing of the machine is under spring tension.
When you release the locking lever, it returns to its highest
position.
7.4
Mounting and adjusting the parallel guide (Fig. 4)
The parallel guide can be used for cutting parallel to the edge of the work-
piece.
Fit the guide rods (a) to the frame using the screws (b).
Release the two lock knobs securing the parallel guide and push them in so
that the guide is at the desired distance from the cutter head.
Tighten the two lock knobs.
Press the guide securely against the edge of the work-piece and execute the
cut.
CAUTION: Abnormal vibrations may be due to a blunt cutter
head.
7.5
Fitting the centre point (Fig. 5)
The centre point is used for routing circles.
Remove a guide rod (a) from the parallel guide.
Mount the centre point (b) to the guide rod.
Slide the guide rod in the router base plate and tighten the lock knobs.
Position the tip of centre point at the centre of your circle.
Press it slightly so that the tip is firmly in the wood. You can now cut the circle.