FE1-30
EN
Copyright © 2015
P a g e
|
6
www.Ford-tools.com
Always check that the mains voltage corresponds to the voltage on the
device's rating plate.
Secure the work piece. The work piece is only secure if it is held by work-
holding devices or in a vice.
Use of extension cables. Only use extension cables which are designed for the
machine's power. The minimum conductor cross section must be 1.5 mm².
When using cable reels the cable must always be completely unrolled.
Always remove the mains plug before replacing saw blades.
Caution: saw blades can get very hot.
Saw blades must be kept sharp and in good condition. Replace partially
fractured and broken saw blades immediately.
Work calmly and evenly with the jig saw. You will thus avoid accidents and the
saw blades and the jig saw will last longer.
7
OPERATING INSTRUCTIONS
7.1
Changing the saw blade
Releasing the saw blade.
Turn the screws anticlockwise
Insert the saw blade in the ram up to the
stop and tighten the two screws of the
retention clip.
Important ! Make sure the saw blade sits
properly in the slot of the roller and ram.
7.2
Switching ON/OFF
Switching ON: Press the On/Off switch.
Continuous operation. Lock the On/Off
switch with the locking button.
Switching Off: Press the On/Off switch and
release.
A: locking button
B: ON/Off switch
7.3
Adjusting the base
Undo the 2 screws to set the base to an
angle up to 45° on the right or left side.