FE1-13
EN
Copyright © 2015
P a g e
|
5
www.Ford-tools.com
power tool
.
If it is damaged, the power tool must be repaired. Many
accidents are caused by using poorly maintained power tools.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to jam and are easier to control
.
Use the power tool, accessories and cutting tools, etc., in accordance
with these instructions and in the manner intended for the particular
type of power tool, taking into account the working conditions and the
work which needs to be done
.
Using a power tool in ways for which it was
not intended can lead to potentially hazardous situations.
5.5
Service
Your power tool should be serviced by a qualified specialist using only
standard spare parts
.
This will ensure that it meets the required safety
standards.
6
SPECIFIC SAFETY INSTRUCTIONS
Always use the auxiliary handle for maximum control.
Secure the material being drilled. Never hold it in your hand or across legs.
Unstable support can cause loose of control and injury.
Do not touch the bit after operation. It could be very hot.
Keep your hand away from under the work piece.
7
ASSEMBLY
Disconnect the power plug before carrying out any adjustments
or maintenance.
7.1
Inserting bit or drill
Open the chuck (1).
Insert the drill or bit in the chuck.
Tighten the chuck firmly.
Check if the bit or drill is in the centre of the chuck.
7.2
Auxiliary handle
The auxiliary handle (8) will provide additional control, support and guidance for
the drill.
Slide the holder of the side grip over the drill chuck on the machine.
Turn the side grip in the required position and tighten it firmly.
7.3
Depth gauge
The depth stop is used to limited the maximum drilling depth.
Loosen the side grip (8).
Insert the depth stop (2) in the hole in the holder of the side grip.
Adjust the depth stop to the required drilling depth.
Tighten the side grip firmly.
