FAT-0113
EN
Copyright © 2015
P a g e
|
4
www.Ford-tools.com
5
FEATURES
Your 2-in-1 Combi Nailer FAT-0113 drives Gauge.18* finish nails from 15mm
to 32mm length and Gauge.18* staples from 16mm to 32mm length.
2-in 1 magazine ,shoot staples and finish nails without adjustment.
Die-cast aluminum body for strong driving and light weight.
Features 360-degree exhaust port can be adjusted to any direction.
Aluminum alloy magazine with large capacity.
Continuous firing for high efficient working.
Excellent for book cases, drawers, window trim, finish paneling, wooden toys,
cabinets and etc.
(* Gauge 18 = thickness x width : 1.25m x 1 mm)
5.1
Air supply
Use clean, Dry and Regulated compressed air at 4-7 bar (60-100psi)
Never exceed maximum and minimum pressure. Too low or too high pressure
would cause noise, fast-worn or misfiring.
When connecting air supply always keep hands and body from discharge area
of tool.
A filter-regulator-lubrication is required and should be located as close to tool
as possible.(see fig.4)
Keep air filter clean. A dirty filter will reduce the air pressure to the tool
causing a reduction in power and efficiency.
For better performance, install a quick connector in your tool and quick coupler
on the hose if possible.
Be sure all connections in air supply system are sealed to prevent air loss.
1.
Tool
2.
Quick connector
3.
Quick coupler
4.
Air hose
5.
Quick connector
6.
Quick coupler
7.
Oiler
8.
Regulator
9.
Filter
10.
Air compressor
