Ford FAT-0103, Инструкция по эксплуатации

Страница: 5 / 9

FAT-0103 EN
Copyright © 2015
P a g e | 4
www.Ford-tools.com
7 IMPORTANT!!!
If a filter/regulator/lubricator is not installed on the air system, air operated tools
should be lubricated at least once a day or after 2 hours work with 2 to 6 drops of
oil, depending on the work environment, directly through the male fitting in the
tool housing.
Fig. 1
1. Tool
2. Quick connector
3. Quick coupler
4. Air hose
5. Quick connector
6. Quick coupler
7. Lubricator
8. Regulator (0-8.5 bar)
9. Filter
10. Cut-off valve
11. Air compressor
8 CONNECTION AND USE
8.1 Installation of the sanding base plate
ƒ
The base plate MUST be:
rated to at least 10,000 mm
-1
.
no larger than 150mm ( 6” ) in diameter with a 3/8” threaded arbor.
dry and clean.
proven undamaged by inspection.
WARNING! TO PREVENT SERIOUS INJURY: Do not operate this
tool without the Sanding Pad properly installed.
ƒ
Turn the spindle lock so that it engages with the drive spindle. This will keep
the drive spindle from freely turning while installing the base plate.
ƒ
Once the drive spindle is locked in place, thread the base plate into the drive
spindle.
ƒ
Once the base plate is securely threaded onto the drive spindle, turn the
spindle lock back, allowing the drive spindle to freely turn.
ƒ
If the spindle lock is still engaged with the drive spindle, the sander will spin
rather than randomly orbit.
ƒ
The sander ONLY uses 6” diameter, hook&loop style sanding paper (not
included).
ƒ
Firmly attach the sanding paper to the base plate.
8.2 Switching on/off
Switching on: push down the trigger
Switching off: release the trigger