Original Instruction Manual
EN
Copyright © 2014
P a g e
|
15
www.Ford-tools.com
The closed disc guard should always point towards the user to protect him from
sparks and chippings.
8.5
Replacing the grinding disc (Fig. 4 – 5)
Beware – a disc which has been used may be very hot!
Fig 4 :
d :two-hole spanner
fig 5 :
a : Outer flange
b : Backing flange
c : Output spindle
!
Depress and hold down the spindle lock button (2) to secure the spindle.
!
Turn the shaft until it locks.
!
Remove the
outer flange (a) and backing flange (b) by using the two-hole
spanner provided.
!
Fit the desired disc (8) on the spindle and replace the outer flange and backing
flange. Release the spindle lock.
Important! Only ever press the spindle lock when the motor
and grinding spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel !
For grinding wheels up to approx. 3 mm thick, screw on the flange nut with the
flat side facing the grinding wheel.
8.6
Switching on / off (Fig. 6)
Before engage the ON/OFF switch button, check that the
grinding disc is properly fitted and run smoothly, the outer
flange is well tightened.
!
Connect the battery pack onto the angle grinder body.
!
To switch on the angle grinder, push the lock-off button (9) to left or right and
squeeze the ON/OFF switch trigger (4)