16
17
MyKey
®
MyKey allows you to program certain
driving restrictions in order to promote
good driving habits. For complete
information, refer to the
MyKey
chapter
in your
Owner’s Manual
.
Wiper Operation
Adjust the wiper lever and its controls to
operate the front and rear wipers.
•
Single wipe: Pull the lever down.
•
Intermittent wipe: Raise the lever
upward to position
1
and then rotate
the control:
-
Upward for short wipe intervals.
-
Downward for long wipe intervals.
• Normal wipe: Raise the lever upward
to position
2
.
•
High-speed wipe: Raise the lever to
position
3
, its highest position.
Speed Dependent Wipers
When your vehicle speed increases, the
interval between wipes decreases.
Rear Window Wiper and Washer
To operate the wiper, press the rocker
switch on the end of the lever to change
between off, intermittent and low speed.
Depending on your vehicle, when you
switch on the front wipers and move the
gearshift lever to reverse (R), the rear
intermittent wipe may turn on.
To use the rear washer, push the wiper
lever away from you. When you release
the lever, the rear wiper operates for a
short time.
Side Sensing System
*
The side sensing system uses the front
and rear side sensors to detect and map
obstacles that are near the sides of your
vehicle. The side sensors are active when
the transmission is in any position other
than park (P). As the object comes
closer to the side of your vehicle, the rate
of the audible warning increases.
Note:
Visibility aids do not replace the
need to watch where the vehicle is
moving. Refer to your Owner’s Manual
for safety information, more details
and limitations.
Rear View Camera
The rear view camera system provides a
video image of the area behind the vehicle.
The image appears when the transmission
is in reverse (R) and uses a variety of
guidelines to alert you of your proximity
to objects. If your vehicle is equipped
with the Obstacle Distance Indicator, the
system provides an image of your vehicle
and the red, yellow and green sensor
zones. For more information about the rear
view camera, please see the
Parking Aids
chapter of your
Owner’s Manua
l.
Note:
If mud, water or debris obstructs the
camera’s view, clean the lens with a soft, lint-
free cloth and non-abrasive cleaner.
Function
*
if equipped
SelectShift
®
Automatic Transmission
With SelectShift automatic transmission, you can use the gear shift to change
gears without a clutch.
Push the + button on the gearshift lever to activate SelectShift.
• Push the toggle switch (+) to upshift.
• Push the toggle switch (–) to downshift.
For more information and system operation, please see the
Transmission
chapter of your
Owner’s Manual
.
SecuriCode
™
Keyless Entry Keypad
*
The SecuriCode keypad is near the driver window and illuminates when touched.
The keypad allows you to lock or unlock the doors without a key. You can operate
the keypad with the factory set, five-digit entry code found on the owner’s
wallet card in the glove box or by using your personal code. You must press each
number within five seconds of each other.
To Unlock the Driver Door
Enter the factory-set code or your personal code. The interior
lamps light.
To Unlock All Doors
Enter the factory-set code or your personal code, then press 3·4
within five seconds.
To Lock All Doors
Press and hold 7·8 and 9·0 at the same time (with the driver door
closed). You do not need to enter the keypad code first.
See the
Doors and Locks
chapter in your
Owner’s Manua
l for more
information on how to use SecuriCode.
*
if equipped
