9/42
SK5W7J-19A361-AA
© Copyright Ford 2005
2W7Z-16A901-AA
Rev Date- 8/29/05
MODULE PREPARATION
Place the supplied fuses into the power distribution
block on the control module. Refer to the fuse
placement drawing for the specific vehicle that you are
working on. Fuse placement drawings are located in
vehicle specific wiring sections.
In this diagram, the parking light fuse is shown in the
positive
polarity position and the Dome light fuse is
shown in the
negative
polarity position.
Note: The HVAC1, HVAC2 and IGNITION fuses are only
used on systems including remote car start (requires
PC-32 module).
Place the software cartridge (DNA) onto the control
module as shown.
Plug the wiring harness(es) into the module.
Harness A: 24-way, used on all systems;
Harness B: 10-way, used on all systems with car start;
Harness C: 16-way, used on systems with convenience
features (i.e. Headlight control, memory seat control)
along with some preload system installations in vehicles
without factory equipped RKE.
If you are installing a system that uses the whip
antenna (RKE, RKE/VSS or Preload), plug the whip
antenna into the module at this time.
1
5
15
15
15
15
15
15
15
5
15
15
15
15
15
-+
-+
HVAC 1
HVAC 2
MAIN B+
IGNITION
DOME LIGHT
DRIVER DOOR UNLOCK/
TRUNK RELEASE
PK LIGHTS
DOOR LOCKS
C
B
A
2
3
