BRAKE FLUID fig. 1-2-3
Release cap
E
:
Check that the liquid
contained in the tank is at the maximum
level.
Fluid level in the reservoir must not
exceed the
MAX
mark.
Use the brake fluid shown in the “Fluids
and lubricants” table (see “Technical
Specifications”).
NOTE Carefully clean the cap of
reservoir
E
and the surrounding
surface.
When opening the cap, make sure that
no dirt gets into the reservoir.
For topping up always use a funnel with
built-in filter (mesh smaller than or
equal to 0.12 mm).
IMPORTANT Brake fluid is hygroscopic
(i.e. it absorbs moisture). For this
reason, if the car is mainly used in areas
with a high degree of atmospheric
humidity, the fluid should be replaced at
more frequent intervals than specified in
the “Service schedule”.
136
W
ARNING
LIGHTS AND MESSAGES
TECHNICAL
SPECIFICA
TIONS
ALPHABETICAL
INDEX
YOUR CAR
SAFETY
ST
AR
TING AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
Prevent brake fluid which is
highly corrosive from
coming into contact with
painted parts. Should that
occur, immediately wash with water.
The brake fluid is
poisonous and highly
corrosive. In case of accidental
contact, wash the parts with water
and mild soap and rinse with plenty
of water. If swallowed immediately
call a doctor.
WARNING
The symbol
π
on the
container indicates a
synthetic brake fluid, which is
different from a mineral fluid. Use
of a mineral type fluid will damage
the special rubber seals of the
braking system beyond repair.
WARNING
131-144 Ford KA GB 17-07-2008 9:16 Pagina 136
