PLEASE READ CAREFULLY BEFORE OPERATION AND KEEP FOR FUTURE REFERENCE.
Install batteries for the RC car and remote control before play.
INSTRUCTION MANUAL
REMOTE CONTROL FUNCTION
PAIRING INSTRUCTIONS
REMOTE CONTROL BATTERY INSTALLATION
BATTERY CHARGING INSTRUCTION
BATTERY SAFETY INSTRUCTIONS
CAR BATTERY INSTALLATION
8+
Fine Adjuster
Power On/Off Button
Note:
Install the batteries by polarity.
Use 1x3.7V 500mAh Lithium Battery (Included)
Use 2x1.5V “AA” Size Baterries (Not Included)
3.7V 500mAh Lithium Battery
1. Do not charge rechargeable batteries without adult supervision.
2. Do not mix old and new batteries or different types of batteries.
3. Only use the recommended types of batteries for the car and the remote control.
4. Remove batteries with low battery charge immediately.
5. Do not short circuit the power supply.
6. Do not disassemble batteries. Dispose old batteries properly.
7. Input voltage of the USB charging cable must be 5V DC and should use input
110-220V (50/60Hz), output 5V 0.5-1.5A. Do not use a fast charger to charge the car.
8. Remove the battery from the car when charging.
9. Regularly check the USB charging cable for damages. If any damage is found,
discontinue use until completely repaired.
10. Please use only the included USB charging cable to charge the RC car battery.
11. Install batteries by correct polarity.
12. Charge time: 120 minutes; Play time: 35 minutes.
Connect USB Cable to 3.7V Lithium Battery.
USB power adapter
(Included)
3.7V 500mAh
Lithium Battery
(Included)
Left
Right
Power Button
Speed Switch
(Low & High)
Forward
Power Light
Indicator
Backward
1. Switch on the RC car then press the Power button on the
remote control.
2. The power light indicator on the remote control will flash
then turn off to signal successful pairing.
3. If the RC car does not respond, please switch off both the car
and the remote control then re-operate the pairing instructions.
Car Power Switch
Press Power
Button on the remote
Power light
indicator will flash
Visit us at https://force1rc.com
