Force S4810P, Установка, Страница: 31 / 49

Installing the S4810 System 31
Replace an AC power supply
To replace a power supply, follow the steps below:
4 Attach power cables.
5 The system powers up as soon as the cables are connected between the power supply and the
power source.
Note: If a power supply fails, it must be completely replaced. There are no field servicable components in
the module itself. Refer to Chapter 8, Technical Support to request a hardware replacement.
Note: If using a single PSU, you must install a blank plate in the other PSU slot. Force10 recommends
using PSU0, if installing only one power supply.
Step Task
1 Disconnect the power cable from the power supply.
2 Use the grab handle to slide the unit out of the power supply bay.
3 Using the grab handle on the replacement unit, slide it into the power supply bay.
4 Tighten the securing screws on the module with a screwdriver. Ensure that the module is secure.
5 Attach power cord to the new module.
6 The system powers up as soon as the cables are connected between the power supply and the
power source.
Step Task