Force LC-EF3-GE-48T, Особенности и инструкции по установке

Страница: 3 / 4

101-00114-01 3
CLI Commands
It is not necessary to configure a slot when you install a new line card into a slot currently occupied by a blank or if
you replace (hot-swap) identical line card types. For more information configuring a slot for a new line card, refer
to the
FTOS Command Line Interface Reference.
To replace the current line card with a different line card type
Pre-configure a line card slot
To view line-card and chassis configurations, use the following commands:
show linecard [
number
] [ brief ]
show chassis
[
brief
]
Step Task
1 Remove the existing line card from the chassis slot.
2
In the CONFIGURATION mode, execute the no linecard
number
command to remove the old line card
type configuration.
In this command,
number
is the chassis slot number (range: 0 to 5).
3
Insert the new line card. FTOS will detect the new line card and enter it in the running configuration.
4
In the EXEC privilege mode, enter the
copy running-config
file-url
CLI command to save the
configuration.
In this command syntax,
file-url
is the location to save the file. To view a list of possible file locations,
enter copy running-config ?
Step Task
1 In the CONFIGURATION mode, enter the
linecard
number card-type
command with the card
information. Where
number
is the chassis slot number (range: 0 to 5) and
card-type
is the line card
indicator.
2
In the EXEC privilege mode, enter the
copy running-config
file-url
command to save the
configuration. Where
file-url
is the location to save the file. To view a list of possible file locations,
enter the
copy running-config ?
command.
3
The slot is now configured for your virtual line card. Ensure that you insert only the line card type that
you named in step 1.