for Living 059-7308-0, Руководство по сборке

Страница: 6 / 12

6
Product No. 059-7308-0
•
Model No. 19391
A
ss
em
bly
Place base on a clean level area outdoors. Do not place on or near surfaces that may be
damaged by water.
Fountain needs to be located near a GFCI (Ground Fault Circuit Interrupter) outdoor
electrical outlet.
To prevent back injuries, please ask for assistance when lifting.
1. Put the base on a clean level surface that will not be damaged by water.
2. Put the pump into the base and run the electrical cord out the hole in the back of the fountain.
3. Run the LED light lead out the same hole in the back of the fountain. It has the end with two prongs. (unhook
from the transformer if it comes assembled.)
4. Connect the transformer to the electrical lead after it has been threaded through the hole in the back then set
down. Plug in after the rest has been assembled.
5. Put the top of the fountain on the base taking care to run the top LED lead and the hose into the centre cavity in
the fountain.
6. Connect all 3 LED fittings to the electrical fittings. BE VERY CAREFUL TO CONNECT FULLY AS WATER CAN
LEAK INTO THE FITTING AND CAUSE THE LED LIGHT TO FAIL IF NOT INSTALLED PROPERLY……(Helpful Hint:
a little Petroleum Jelly will help).
7. Connect the hose to the outlet on the top of the pump.
8. Fill with clean water.
9. Plug the pump and transformer into a properly grounded outdoor outlet.
Test run and adjust the water flow by twisting the tab located on the front of the pump to get the desired effect.
Troubleshooting:
If water does not flow out of unit, disconnect the power supply and verify that there are no kinks in the hose. Shake
the pump a little while underwater to remove any trapped air in the unit.
Remove any visible debris.
Make sure there is enough water in the fountain. Fill to within 1–2" (2.5–5 cm) inches below the rim of the base
(Fountain – Lower Section).
Connect and disconnect the power a few times. The pump should function.
Wait a while in order to allow the water to circulate properly.
General Information:
Adaptor model number: GPU351200200WAOO AC 120V ˜60Hz.
Pump model number: YH-606 AC 120V ˜60Hz. A
Power cord is 6 ft (1.83 m) long.