FOR-A HVS-XT100, Руководство по эксплуатации

Страница: 186 / 236

186
20-4. Editor Control (HVS-XT100ED)
The switcher can be controlled from an editor through an RS-422 interface.
The HVS-XT100ED software option is required for editor control.
Use an RS-422 cross-over cable for the editor connection.
20-4-1. RS-422 Port Settings
(1) Open the [SETUP - SYSTEM - RS-422] menu.
(2) To connect the editor to the RS-422(2) port, set the menu as shown below. The BAUD
rate and PARITY are automatically set.
SYSTEM :SELECT :FUNC :BAUDRAT:PARITY : 1/1
RS-422 : =
PORT2 : = EDIT : =34800: =ODD :
(3) After settings are complete, reboot the switcher.

See section 19-1. "Rebooting System."
20-4-2. Editor Control Settings
(1) Open the [SETUP - EXT I/F - EDITOR] menu.
(2) Select a protocol under
TYPE between DVS(SONY DVS/BVS series compatible) and
GVG-K/Z.
FUNCTION: TYPE :ENABLE :SELECT : WIPE : 1/2
EDITOR : =
DVS : =OFF : =ME : =NORML:
If DVS is used:
If DVS is used, the bus to be controlled from the editor must be specified. Refer to the
table below to set the bus under
SELECT . If PREV, PREV ON or ALL is set, AUX1 will be
the edit preview bus and its crosspoint number is 46. Set your editor accordingly.
Setting Description
ME Controls the M/E bus when ENABLE is ON.
PREV Controls the preview bus when ENABLE is ON.
ALL Controls both M/E bus and preview bus when ENABLE is ON.
ME ON
Always controls the M/E bus regardless of the ENABLE setting.
Controls both M/E bus and preview bus when ENABLE is ON.
PREV ON
Always controls the preview bus regardless of the ENABLE setting.
Controls both M/E bus and preview bus when ENABLE is ON.
If G-K/Z (GVG protocol) is used:
Select a pattern control mode between the two below at WIPE .
Setting Description
NORMAL
Same wipe pattern numbers (0-99) as in the switcher are used in the editor.
(default setting)
LIST
Ten wipe patterns saved to Direct Pattern memory are used in the editor as
Direct Pattern No. 90-99. (GVG-Protocol only)